12
Before use, the mitre saw can be xed to a rm, level and
stable supporting surface, such as a workbench.
Four mounting holes have been provided in the base
plate for this purpose. Each of these four mounting holes
should be securely bolted using appropriate machine
bolt with suitable lock washer and hex nut (not supplied).
To mount the saw, proceed as follows:
1) Locate and mark where the saw is to be mounted.
2) Drill 4 holes through the surface.
3) Place the sliding mitre saw on the surface aligning
holes in base with holes drilled in the surface.
4) Install and tighten the bolts, washers and hex nuts.
Carefully check the workbench after mounting the saw
to make sure that no movement can occur during use.
If any tipping, sliding or walking is noted, secure the
workbench to the oor before operating.
NOTE: The saw can be used without the need to mount.
However, if you will be using the saw for a long period of
time, we advise that it is mounted securely.
4. MOUNTING BOLT (SEE FIG. D)
When cutting workpieces, they should always be
clamped with a work clamp. The work clamp can be
tted on either side of the saw and is fully adjustable to
suit the size of the workpiece.
To install the work clamp, just insert it into the hole
located at rear of the fence on either side of the base
plate. Work clamp lock knob is used to secure the work
clamp on the base plate. Adjustment knob (a) is used to
adjust the height of the rail (c).
Adjustment knob (b) is used to lock the workpieces.
NOTE:
• Do not operate the saw without clamping the
workpiece.
• Make sure that the work clamp securing screws are
tightened.
3. WORK CLAMP (SEE FIG. C)
a
b
c
1
1
1
1
Fig. C
Fig. D
To Next Page
Loading...
