Wickes CID18W2 - Operating Instructions

To Next Page

To Previous Page

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.

Intended Use

The power tool is intended for driving in and loosening screws

BEFORE PUTTING INTO OPERATION

a)Donotuseanychargerotherthanthatspecicallyprovidedforusewiththeequipment.

b) If the battery pack is very hot you must remove your battery pack from the charger and allow time for the battery

to cool down before recharging.

c) The battery in your new tool is not charged when it leaves the factory. It must be fully charged before using for the

rsttime.

d) The battery must be fully charged before storage. If the tool is not used for long periods, recharge the battery at

least every 3-6 months.

DepresstheBatteryPackReleaseButton(6)rmlyrst

and then slide the Battery Pack (8) out from your tool.

Slide the fully charged Battery Pack (7) onto the tool with

sufcientforceuntilitclicksintoposition.

B) TO REMOVE THE BATTERY PACK (See Fig. A1)

A) CHARGING THE BATTERY

C) TO INSTALL THE BATTERY PACK (See Fig. A2)

Fig. A1

Fig. A2