14
7. DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of the battery pack properly. This battery pack contains
Lithium batteries. Consult your local waste authority for information regarding available recycling and/or disposal
options. Discharge your battery pack by operating your drill, then remove the battery pack from the drill housing
and cover the battery pack connections with heavy-duty adhesive tape to prevent short circuit and energy discharge. Do
not attempt to open or remove any of the components.
8. OVERLOAD PROTECTION
9. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
10. PROTECTION AGAINST DEEP DISCHARGING
When overloaded, the motor comes to a stop. Relieve the load on the machine immediately and allow cooling for approx.
30 seconds at the highest no-load speed.
This power tool has over-load protection built in. If the load is too high or the battery temperature exceeds 75°C, the
electronic control switches off the power tool until the battery has cooled
The Li-ion battery is protected against deep discharging by the “Discharging Protection System”. When the battery is
empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates.
To Next Page
Loading...