WiKa Technology LightFire - Instructions for Lighting; After Use



31

3.3. Instructionsforlighting
WhenusingtheLightFireinFire‐Mode,pleaseuseonlyknots,
bark,woodor relatedproductsfromthe trade.Protecttheflora
and fauna by leaving untouched living trees and plants. If you
wanttoblowyourfire,blowevenlyintothefire'sembers.Donot
blow too hard toavoid flying sparks. Alternatively,you can turn
thefrontoftheLightFireagainstthewindsothatthewindblows
thefire.Attention,flyingsparks!

3.4. Afteruse:
Instructionsforcleaningandcare
When you have finished the fire, wait until the embers are
completelyextinguished,donotdeglazewithwater.Removethe
ash after cooling and dispose ofitproperly.Wearprotective
glovesforprotection.Eliminateanycombustionresidueandleave
thelocationwheretheLightFirewasused,asyoufoundit.For
safety'ssake,wipethesurfacewithwater.
TheLightFiregetsabrowncolourduetoitsuseandcaneasilybe
warped physically. However, this behaviour does not affect the
functionalityandefficiencyoftheLightFireanddoesnotwarrant
anywarranty.Remedycanbecreatedbyacontactoftheitemsat
thenextuse.
If you want to clean the LightFire, rinse it with a soft cloth or
sponge and environmentally friendly soap. If the LightFire is
cleanedinnature,disposeoftherinsewaterawayfromwater.
Observewaterconservationandnaturereserves!Donotusesteel
orironwirebrushesorleavethemlyinginthewaterunused.This
canleadtorusting,forwhichwecannotguarantee.
If your LightFire bag is dirty, please wash it in hand wash with
environmentallyfriendlysoap.
 