Page 15 of 24 pages
Norsk
follows:
Fuel type Length in cm Diameter in cm
20-30 2-5
Chopped wood 20-30 7-10
Using the Air Damper
located under the stove door; see drawing D.
When lighting a cold stove and when fuellingwith new wood, the regulating lever must be pu-
air supply can be gradually reduced by moving the regulating lever to the right.
stove has been allowed to go out completely in connection with cleaning, for instance.
Special re lighting guide for stoves with stone and tile cladding
Stone are natural products which need to adjust to temperature changes. We recommend
following the procedure below:
1. First stoking
Move the air control lever to the extreme left to fully open the air supply to
-
close the stove door. If condensation forms on the glass, keep the door
ajar for a little while and close again.
temperature.
2. Second stoking
Move the air control lever to the extreme left to fully open the air supply to the combustion
-
stove door. If condensation forms on the glass, keep the door ajar for a little while and close
again. The layer of embers is suitable when the pieces of wood begin to disintegrate and the
air supply can be gradually reduced by moving the air control lever to the right until uniform,
before stoking again.
3. Third stoking
Restoking
Follow the general instructions, see the sections “Lighting the stove” and “Stoking”.
To Next Page
Loading...
