Page 19 of 24 pages
Insulation
-
plate can cause secondary air to become incorrectly distributed in the combustion chamber,
and it should therefore be replaced. However, it should be replaced, if there are actual holes
than half its original thickness.
WIKING
®
Automatic™
The spring in the automatism should be controlled at least once every second year.
WIKING Miro 1-4 (Drawing G1):
plate of the stove. On a cold stove, the starting point of the feeler is controlled. The starting
point on a cold stove is about 10
0
above horizontal. It should feel easy going and bouncy when
you push it, no matter if the stove is cold or hot. Mount the rear plate, the side plates and the
top plate again.
WIKING Miro 5-6 (Drawing G2):
both sides of the heat storage compartment. Open the door to the wood section and remove
On a cold stove, the starting point of the feeler is controlled. The starting point on a cold stove
is about 10
0
above horizontal. It should feel easy going and bouncy when you push it, no matter
if the stove is cold or hot. Re-mount the rear plate, the side plates, the bottom plate in the heat
storage compartment, the front of the heat storage compartment and the top plate.
WIKING Miro 4/WIKING Miro 6 with soapstone cover (Drawing G3): Remove the rear plate
of the stove. On a cold stove, the starting point of the feeler is controlled. The starting point on
a cold stove is about 10
0
above horizontal. It should feel easy going and bouncy when you push
it, no matter if the stove is cold or hot. Remount the rear plate.
Door/glass
A sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go
should also ensure that air gaps in the door frame are free of ash and soot particles.
Seals
Check frequently to ensure that seals in the door and ash pan are intact and not brittle. Failing
this, they should be replaced. Use original seals only.
Surface
Usually, it is not necessary to any treatment to the painted surfaces of the wood-burning stove.
Any damage to the paint may, however, be remedied with spray paint, which can be bought
from your stove retailer.
Guarantee
To Next Page
Loading...
