Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 Rev. 06/17#59504276
12. Insert straps up through looped bungee on the seat back riser assembly
13. Insert straps and bungee w/ hooks up inside the large opening on back of the seat back.
14. Locate U-shaped slot in spine of seat back (as shown here) Insert the looped bungee in U-shaped slot. At this
point, riser should be upside down with pivot nub on the top left.
15. Pinch looped bungee to hold it in place under U-shaped slot in seat back spine, then flip riser over so it is right
side up and positioned to be inserted into seat back spine.
To Next Page
