1. Press the“ ”button to turn on front/rear lights. The brightness of display will
automatic lower.
2. Press“+/-”button to increase or decrease the pedal assist level(PAS). When set to higher
numbers, the motor will come on stronger. On lower numbers, it will be more gentle.
Level 0 is with no power. The default setting is Level 1.
3. Press“ i ”button to toggle Trip, Odometer, Max speed and Average speed.
4. Long press“ + ”button to enter cruise control mode. After“ ”shows on the display,
press and hold the throttle for about 8S to activate cruise control. Long press and hold
“ - ”button to activate walk mode. The bike will walk at a speed of 6km/h. Release
“ - ”button to exit the walk mode.
5. This battery indicator shows the estimated charge level left in the bike’s battery. Each bar
indicates an approximate 20% charge. The battery display will flash when there is no
charge remaining.
17
Error Code
E021
E022
E023
E024
E025
E030
Definition
Abnormal current
Handlebar failure
Default phase of motor
Hall element failure
Brake failure
Communication failure
To Next Page
Loading...