DMX Address Mode
Select the DMX address mode by pressing the select button until the yellow DMX Address LED is lit. The
display will read the last DMX address selected. Set the desired DMX address (001 to 512) by pressing the up
or down buttons. Pressing either the up or down buttons for longer then 3 seconds will cause the display to
move up or down rapidly. Once the fixture receives a DMX signal with a data value of 140 or above the lamp will
strike. When the data value falls to 120 or below the lamp will extinguish. If power and or DMX signal to the
fixture is lost, the last address selected will be retained when power and or DMX signal is regained. The DMX
input/output connector pin configuration is: Common Pin 1, Data Minus Pin 2 and Data Plus Pin 3. Pins 4 and 5
are not used at this time.
To operate the fixture without DMX, set the address to 702. This forces the fixture on regardless if DMX signal is
present or not. This is the default address setting when the fixture ships from the factory
Lamp Timer Mode
Select this mode by pressing the select button until the red Lamp Timer LED is lit. The display will show the
current hours on the lamp in the fixture. When it reaches 1000 the red LED will flash continuously to let you
know it is time to change the lamp. If another mode is selected when the lamp timer is at 1000 hours or over the
display will always default back to the lamp timer mode within 10 seconds until the lamp timer is reset or rolls
over at 9999 hours. Pressing and holding the up & down buttons simultaneously for 5 seconds while in the lamp
timer mode will reset the lamp timer. If the fixture is powered up and the lamp doesn't ignite, the display will flash
"O F F" while in this mode until the lamp ignites. If another mode is selected at this time, the display will always
default back to the Lamp Timer mode in 10 seconds until the lamp ignites. The lamp timer will retain the current
hours on the lamp even when the fixture is unplugged
DMX Data Mode
To select this mode, press the select button until the green DMX Data LED is lit. The display will read the data
value of the DMX signal being received. When a DMX data value of 140 or greater is received, the fixture will
turn on. When a data value of 120 or less is received the fixture will turn off. If power is removed and DMX
signal is still present, the current data value being sent to the fixture will be read as soon as power is reapplied.
If no DMX signal is being received or DMX signal is lost, the DMX data LED will flash, the display will read
"0 0 0" and the fixture will default to off unless the DMX address is set to 702 as indicated above. If another
mode is selected at this time, the display will always default back to the DMX data mode in 10 seconds until the
DMX signal is restored or the address is set to 702.
Dark Mode
Pressing and holding the select button for 5 seconds in any of the three modes will darken the display and LED
while still retaining all information. To turn the display back on press the select button again
6
To Next Page
Loading...