Wildix W-AIR handsets: W-AIR Basic (ex W-AIR 70), W-AIR 100 (End Of Life), W-AIR LifeSaver (ex W-AIR 150),
W-AIR Med, W-AIR Office and W-AIR Headset. Follow the online Guides to get detailed information: W-AIR
DECT Handsets Guide, W-AIR Headset Guide.
Multicell network scalability and features
Sync over the air with W-AIR Base, W-AIR Base Outdoor or mixed network in which W-AIR Bases Sync Plus are
present:
Up to 1000 users per system
Up to 250 bases
Up to 30 handsets registered to one base station*
Up to 3 Repeaters per base
Up to 50 bases - 3 repeaters
50-125 bases - 1 repeater
More than 125 bases - no repeater
Up to 100 Repeaters registered to one system
Up to 8 concurrent calls** per base
8 narrow band audio channels per base
4 CAT-iq wideband audio channels per base
(Single cell setup) Max 10 concurrent calls per base
Handover through the base station (max. 8 simultaneous handovers)
Up to 5 concurrent calls per repeater
Up to 24 sync levels
Base station indoor range: 50 m; outdoor range: 300m
Planning a multicell network
Before you start
*Note: by default W-AIR system supports up to 20 devices, to increase the number to 30 devices, use
Custom Provisioning parameter, described in this document: https://confluence.wildix.com/x/KQg8AQ
** Enabling PTT feature (Push-to-talk) on W-AIR handsets reduces the number of available channels on
each base station to 6.
Important:
Base stations can sync over the air only in case they are able to see each other.
They see each other if the dBm value is between -75 and 0.
Repeater which is placed between the two Base stations can only extend the coverage but cannot
perform the sync.
To Next Page
Loading...