Wildix W-AIR Base - User Manual

W-AIR Network Admin Guide - Sync over the air
W-AIR Network Admin Guide - Sync over the air
Page 1 of 27
Mar 29, 2020 04:21
W-AIR Network Admin Guide - Sync over the air
Description
System architecture
Multicell network scalability and features
Planning a multicell network
Before you start
Handover and Roaming
Handover
Roaming
Deployment considerations
Capacity planning
Site Survey
Requirements
How to check RSSI level
Placing the first base station
Check the Radio Coverage
Handset
Base station
Repeaters
Base station/ Repeater Placement Strategy
Radiation pattern - base optimal position for optimal coverage
Base station and repeaters connection and overview
Packing lists
Base stations mounting, connection and reset
LEDs of the Base Stations
Mounting instructions
Find Base station IP
Repeaters connection and overview
Repeater connection and reset
LEDs of the Repeaters
W-AIR Network configuration
Step 1. Provision base stations
Step 2. Create a W-AIR Network
This guide leads you through installation of W-AIR Base and W-AIR Base Outdoor and setting up a W-
AIR DECT Network in which the bases sync over the air.
Updated: June 2016
Permalink: https://confluence.wildix.com/x/IADfAg
W-AIR Base is End Of Life.

Summary

Description

System architecture

Multicell network scalability and features

Details the capacity and functionalities of multicell networks.

Planning a multicell network

Handover and Roaming

Handover

Explains the process of transferring calls between base stations without interruption.

Roaming

Describes how handsets move SIP and DECT registrations between base stations.

Deployment considerations

Radio; Cell Range

Site Survey

How to check RSSI level

Provides steps to measure signal strength on a handset.

Placing the first base station

Guides on the initial placement and verification of a base station.

Check the Radio Coverage

Base station and repeaters connection and overview

Base stations mounting, connection and reset

Step-by-step guide for installing and managing base stations.

W-AIR Network configuration

Step 1. Provision base stations

Guides on adding base stations to the WMS.

Step 2. Create a W-AIR Network

Explains how to define and configure the W-AIR network.

Step 3. Register a W-AIR Handset

To register the handset

Steps to initiate the handset registration process.

To assign the handset

Steps to assign a registered handset to a user.

Step 4. Set up Repeaters

System combination (Number of base stations;Repeaters per base station)

W-AIR Network deployment

Case 1: Sync chain with one Primary Base

Describes a basic sync chain deployment.

Verify deployment

Upgrade Procedure of W-AIR system

FW upgrade of Base Stations

Steps to upgrade firmware on base stations.

FW upgrade of Repeaters and Handsets

Steps to upgrade firmware on repeaters and handsets.

Alarms setting

Types of alarms

Set up emergency profiles

Assign emergency profile to handsets

Wildix W-AIR Base Specifications

General

Type	DECT base station
Category	Accessories
Radio Technology	DECT
Connectivity	Ethernet
Number of simultaneous calls	8
Power Supply	PoE (Power over Ethernet)
LAN ports	1
Protocols	SIP
Compatibility	Wildix W-AIR handsets
Mounting	Wall
Charging	No