wildkin Slatted Step Stool - Assembly Steps; Attach Side Panels to Step

Page 2 of 2
P: 866-727-0544 E: customercare@wildkin.com www.wildkin.com
1. Align holes on Left Side Panel (B) with pegs on Slatted Step (A).
s7
s7
C
B
Peg
A
2. Insert Large Screw (s7) into holes on Left Side Panel (B) and tighten with Allen Wrench (o2) until
secure.
* Hint: If the Large Screws (s7) do not screw in properly, be sure that each nut sleeve in Slatted
Step (A) is aligned with the hole. You can check the alignment by looking through each hole on the
side of Slatted Step (A). If not aligned, use screwdriver to turn nut sleeve until it aligns.
secure.
4. Insert Large Screw (s7) into holes on Right Side Panel (C) and tighten with Allen Wrench (o2) until
3. Align holes on Right Side Panel (C) with pegs on Slatted Step (A).
Figure 1: Attach Side Panels to Slatted Step
Slatted Step Stool Assembly Instructions