STC-TGL1
www.wildviewcam.com Toll Free 888-304-6125
17
• If your computer doesn’t run automatically, please click “Start”
button and choose “Run”, and then browse the CD drive and
click “Setup”.
Viewing the images on your computer
• Slide the power switch to OFF location.
• To view the images simply plug one end of the USB cable into
an available USB port on your computer.
• Plug the other end of USB cable into the camera. The camera
will automatically power ON. Front LCD screen will show “USb”
• At the same time, your computer will recognize the camera as
mass storage device and found under MY COMPUTER.
To Next Page
Loading...
