9
BEFORE USE
Electrical connection
Check that the voltage where you shall use the unit is the same as that specified
on the unit. Details can be found on the label on the unit’s base plate.
When using the unit for the first time
Please run fresh water through the unit without using a coffee filter or coffee
prior to using the unit for the first time.
OPERATION
• Place the Wilfa SVART Performance on a flat surface. Plug the power cord
into the socket.
• Turn the on/off power switch on. Start button will blink twice and one beep
will be heard.
• Fill the water tank with fresh water to the desired amount. Place a filter
paper (1x4) in the filter holder. Place the recommended amount of coffee
into the filter.
• We recommend that you use filter ground coffee, 60 g per litre of water.
Experiment with the coffee quantities for the first few brewing’s to find the
amount which you think is optimal.
• We also recommend that you use a Wilfa scale for best results.
• Attach the filter holder to the bracket. Set the flow control in relation to
your desired brew preference.
• We recommend the following ratios of water and coffee (please note that
different grinds and coffee types will influence these ratios somewhat):
1,25 l - 75 g
1 l - 60 g
0,75 l - 45 g
0,50 l - 30 g
• Press the start button to start the brewing process. Wilfa SVART
Performance has Wilfa’s unique pump system which transports water
through the system at an optimal temperature from the first to the last
drop.
• When the brewing process is complete, the unit will switch over to the keep
warm state. The start button will remain lit up. After 40 minutes the coffee
maker will automatically be switched off. If you want to switch off the coffee
To Next Page
Loading...