Wilfa Cool 7 - WATER DRAINAGE PROCEDURES; Bottom Hole Drainage Method

21
English
English
REMOVING COLLECTED WATER
There are 2 ways to remove collected water:
➊ Use drainage option from the bottom hole.
Note: When using drainage option from the bottom hole, install drainage pipe before using,
otherwise poor drainage will affect normal operation of the unit.
Instructions for drainage pipe installation as follows:
1. Remove the rubber plug at drainage port.
drainage port
2. Fix the drainage pipe clip on the right of rear side plate near drainage port with
a screw.
drainage port
drainage pipe clip
screw
3. Put the drainage pipe into drainage port and screw it up, and then bind it with
pipe hoop.