Wilfa E2 - Scooter Assembly; Initial Setup and Securing

Open the rubber plug
Insert the charging plug Fill and fix the rubber
plug after charging
3. Charging
Your scooter will be fully charged when the LED light on the charger changes from red (charging) to green.
Do
not charge your scooter for long time.
Do
not connect the charger if the charging port is wet. Cover the charging port when not use.
Charge the scooter every two months if you are not going to use it for a long time to avoid damage of battery
4. Driving learning
Always wear a helmet and safety gear to
a
void injury during driving, as shown in the
figure.
5 6
2. One foot stands on the pedal and the other
foot slide on the ground.
3. When the electric scooter begins to glide, put
bo
th feet on the deck and press the accelerator
.
Th
e speed shall be kept above 5km/h for startin
g
the throttle.
4. Release the throttle to reduce the speed
s
lowly. Squeeze the brake lever for a sudden
brake.
0. Tilt your body to the steering direction as you
turn and turn the handlebar slowly.
00
1. Turn the power on and check the battery indicator.