Wilfa HAZE - Night Mode; Timer; Degerming; Mist Output Speed

11
EN
HAZE · HU-400BC
• Night mode: Long press the humidity button for 2 seconds to shut down the
water tank indicator light and display. Only the red On/off button will show.
Press any button to wake up the light and display.
• Timer: There is 12 timer settings: 1-12. Touch the TIMER button and the
display will show the timer setting from 1-12 in sequence. For example “1H”.
Once you have found your preferred time setting, do not operate it for 3
seconds, the time will stop ashing and the timer is set. The timer shows the
rest of the operating time every minute. Press the timer button for 2 seconds
to cancel the operation.
• Degerming: Touch the DEGERMING button once to start the heating
function. The display shows the heating symbol . Warm mist will come out
after 10-15 minutes. Touch the button again to start the plasma function. The
plasma symbol will show on the display. Touch the button again to shut
down the heating function. Touch the button one more time to shut down the
plasma function. Long press the degerming button to tun on/off water tank
indicator light.
• Mist output speed: Touch the bar to enter manual mode.
Slide from MIN to MAX to select your preferred mist output speed. Sliding
from left to right will increase the speed, sliding from MAX to MIN will
decrease the speed. The display shows the selected speed from 1-5.
• Auto shut down: If there is not enough water in the water tank to keep the
humidier going, the humidier will automatically stop working and stay
at standby mode. The water shortage symbol will show on the display.
Rell the water tank and press the on/off button to turn the humidier on
again. If there is too much water in the basin, the display shows EF, and it will
automatically stop working. Pour out some of the excess water and put the
water tank back into the main base, switch it on and it will work as normal.