EasyManua.ls Logo

Wilfa HU-400BCA - Use

Wilfa HU-400BCA
224 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
INSTRUCTION MANUAL · HUMIDIFIER
EN
USE
Remove the top cover, ll water into the water tank, and put the top cover
back on. You can also take the water tank out and ll water directly into the
tank, and put the water tank back into the main base.
Check if the rated voltage meets the input voltage, and plug into the
socket. The display will light up and it beeps one time. 1 second later, the
display will turn off, and the “on/off” button will turn red, meaning the
humidier is in standby mode.
Touch the “on/off” button, the display will light up, and it will start to
work in AUTO mode. The display shows the auto symbol and current
humidity. 10 seconds later, the display shows current temperature, and
then change into humidity. Current temperature and humidity showing will
change once every minute.
Humidier will decide running humidity based on current temperature as
below.
Constant humidity: touch the HUMIDITY button and you can select the
humidity from 30%RM to 75%. Touch the button once and it will increase
by 5%RH each time. When it reaches 75%, touch again and the display will
show “—” and the humidier will go back to AUTO mode. After setting
the preferred humidity, humidier will keep the memory and conrm by
ashing 3 seconds. Once the display switches to show current humidity, it
means that the setting is nished, “%” will ash on the display.
When setting humidity is 1%RH~9%RH higher than current humidity, mist
output speed will run by the lowest (the rst) speed.
When setting humidity is 10%RH~15%RH higher than current humidity,
mist output speed will run by the middle (the third) speed.
When setting humidity is 15%RH higher than current humidity, mist
output speed will run by the highest (the fth) speed.
When current humidity is higher than setting humidity, humidier will
turn into sleep state. Once current humidity is 3%RH lower than setting
humidity, humidier will re-work in previous working mode till water
shortage.
Temperature
of the air,
degrees
Celsius
≤19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 ≥37
Humidity (%)
65 60 58 57 55 53 50 48 45 43 40 38 36 35 34 32 31 30 25