Wilfa UNIFORM - Troubleshooting

10
EN
INSTRUCTION MANUAL · UNIFORM
TROUBLESHOOTING
Problem Possible causes Solution
Coffee grinder
does not start
Power cord is not plugged in Plug into power socket
Bean hopper is not in correct
position
Rotate the bean hopper
properly into locked position.
Coffee grinder
clogs
Using setting 1-4 might clog
the burrs.
Set grinder to 25 and
gradually adjust back to
the wanted setting while
the motor is running with
beans in the hopper. This
will remove clogging of the
burrs.
Depending on type of beans,
wear and factory calibration
the machine might clog at
the nest settings.
To nd the nest setting
before clogging: Lower
setting gradually until the
burrs clog. If it clogs at
setting 3 then setting 4
should be considered as
nest setting.
Coffee grinder
grinds to
coarse even at
nest settings
Bean hopper not fully rotated
in place.
If the beans are grinded
coarse even on the ner
settings the head might not
be in place. Try to rotate
the bean hopper one more
revolution.
It’s hard to
adjust to ner
settings
Grinded beans might stuck
between the burrs.
Let the motor run while
adjusting to a ner setting.