Williams 96 Series - User Manual

To Next Page

96 & 97 LED SERIES

INSTALLATION INSTRUCTIONS

H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065

Information contained herein is subject to change without notice.

PN #49090174

Page 1 of 2

REV.12/20/23.JL

WARNING:

■

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

■

Make sure all electrical power is turned off while installing the fixture.

■

This luminaire must be adequately grounded for protection against

shock hazards and to assure proper operation.

■

Disconnect power before servicing.

■

LEDs are ESD (Electro Static Discharge) sensitive devices that can be

easily damaged if the proper ESD mitigating steps are not taken.

■

LEDs are very sensitive to mechanical damage. Caution must be taken

to avoid damage to the LEDs.

■

ESD or mechanical damage voids all warranties.

■

Suitable for wet locations.

FIXTURE DETAIL

ENSURE THE LENS IS PROPERLY SEATED AND CENTERED IN THE GASKETED GROOVE PRIOR TO CLOSING THE LATCHES. FAILURE TO DO SO

CAN RESULT IN DAMAGING THE LENS, LEADING TO LENS FAILURES THAT ARE NOT COVERED UNDER WARRANTY.

Note: Use the illustrations below when assembling or disassembling the fixture. (96, 4′ shown)

Latch

Mounting bracket

Wireway cover

Lens

Fiberglass housin

End plug

BACKVIEW

OVERALL

LENGTH (A)

MOUNTING

DISTANCE (B)

2′

27-5/8″ 12″- 17″ OC

4′

51-7/8″ 30″- 42″ OC

8′

100-1/4″ 48″- 80″ OC

TABLE OF CONTENTS

FIXTURE DETAIL ................................................................................................. 1

WIRING DIAGRAM.............................................................................................2

INSTALLATION ................................................................................................... 2

Need help?

Do you have a question about the Williams 96 Series and is the answer not in the manual?

Summary

Fixture Detail and Overview

Fixture Detail Description

Ensures lens seating for warranty; provides component labels.

Backview Dimensions

Provides overall length and mounting distance specifications for fixture sizes.

Wiring Diagram

Installation Steps

Step 1: Secure Mounting Brackets

Attach mounting brackets to the surface with specified spacing for fixture lengths.

Step 2: Insert Housing into Brackets

Place one side of the fixture enclosure into the installed mounting brackets.

Step 3: Engage Mounting Bracket

Push enclosure up and press bracket until it clicks into place.

Step 4: Verify Support and Connect Power

Confirm enclosure is fully supported before electrical connection.