To Next PageTo Next Page
Need help?Do you have a question about the Wilo COR 2MHI Series and is the answer not in the manual?
General| Brand | Wilo |
|---|---|
| Model | COR 2MHI Series |
| Category | Industrial Equipment |
| Language | English |
Describes the SCe booster set for maintaining water pressure in various applications.
Covers essential safety information and precautions for users of the SCe booster sets.
Explains hazard symbols (DANGER, WARNING, ATTENTION, NOTE) and their meanings.
Prohibits modifications and mandates the use of Wilo approved spares to maintain warranty.
Provides guidelines for safe transport by pallet and storage in a dry environment.
Explains the function of the Smart Control (SCe) controller in maintaining system pressure.
Lists key operating features like multiple pressure set points and pump cycling.
Details the operation of the variable speed three-phase booster set.
Details the operation of the variable speed single-phase booster set.
Specifies installation on a flat concrete floor with vibration absorbers.
Guidance on connecting the booster set to the mains water supply and tank.
Emphasizes hygiene requirements for drinking water applications.
Advice on correct wiring diagrams and voltage application for safety.
Explains low water cut-out switch settings and function for dry run protection.
Details booster set operation and essential controller settings.
Recommends commissioning by qualified personnel and outlines initial steps.
Recommends annual maintenance and lists essential checks for reliability.
Outlines warranty terms and information required for service visits.
Lists fault codes for SCe Panel (EM & DM) and SCe-DM Drive for troubleshooting.
Lists spare parts for the COR 2 MHI series booster sets.
Lists spare parts for the COR 3 MHI series booster sets.
Lists spare parts for the COR 2-3 MHIE series booster sets.
Declares compliance of the SCe-EM & SCe-DM series with relevant EU directives and standards.
