What to do if the UVC lamp does not light up on my WilTec Other?
If the UVC lamp of your WilTec Other does not light up, first ensure the plug is properly connected. If it is, the UVC lamp may be defective and require replacing. Also, check the electrical connection for any defects. If the UVC has overheated, it will automatically switch on once it has cooled down.
Why is the performance of my WilTec Other unit not satisfactory?
If the performance of your WilTec Other unit is not satisfactory, it might be due to several reasons. The water may be extremely soiled; in this case, remove algae and leaves from the pond and perform a partial water change. Alternatively, the quartz glass tube could be soiled, requiring cleaning. Finally, the UVC lamp capacity may be exhausted, meaning it's time to replace the lamp after approximately 8000 operating hours.
Table detailing technical specifications for various UVC clarifier models.
Exploded view diagram identifying individual components of the UVC device.
Common malfunctions, their causes, and recommended remedies for the UVC device.
General| Power | 18 W |
|---|---|
| Voltage | 230V/50Hz |
| Inlet | 25/32/38 mm |
| Outlet | 25/32/38 mm |
| Type | UV clarifier |
To Next Page