WilTec SKD-5 - User Manual

To Next Page

Operation Manual

SKD-5 – Pressure Switch

50612, 51249

Illustration similar, may vary depending on model

Read and follow the operating instructions and safety information before using for the first time.

Technical changes reserved!

Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.

Updating the documentation

If you have suggestions for improvement or have found any irregularities, please contact us.

Need help?

Do you have a question about the WilTec SKD-5 and is the answer not in the manual?

WilTec SKD-5 Specifications

General

Specifies operating conditions for the pumped liquid and prohibited liquid types.

Details the required power connection, voltage, frequency, and fuse protection.

Identifies numbered components of the pressure switch shown in a diagram.

Lists key technical specifications including voltage, pressure, connections, and protection type.

Explains the general operating mode based on pressure and flow switch states.

Details common operational errors and their potential causes and solutions.

Provides crucial guidelines for installing the pump control, including height and water column limits.

Specifies the required inlet pressure for the pump and the automat's setting.

Illustrates electrical connection diagrams for single-phase and three-phase pumps.

Lists common errors and their possible causes, both at the machine and externally.