Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
ATTENTION:
The use of this device is allowed on standing water bodies, garden ponds or swimming ponds and
their surrounding areas only with fault current protection-switch with a triggering nominal current up to
30=mA (according to VDE 0100 Article 702 and 738).
The device is not suitable for use in swimming pools, paddling pools and other bodies of water where
people swim during operation. The operation of the device is not allowed whilst people are in the
danger zone. Ask your electrician.
The device is not intended for use by persons (including children) with impaired or limited physical,
sensory and mental abilities or lack of experience and/or real knowledge, unless they are supervised
by a person responsible for their safety or have received by this person instructions on how to use the
device correctly.
Children should be supervised to make sure that they do not play with the device.
ATTENTION:
Perform a visual inspection of the device before every use. Do not use the device if the safety
appliances are damaged or worn out. Never override safety regulations.
Use the device exclusively according to the intended purpose stated in the instructions for
use.
You are responsible for the safety of the working environment.
If the cable or the plug is damaged due to external influences the cable must not be repaired!
It has to be replaced with a new one. This work can be carried out only by an electrician.
The voltage indicated on the type plate of the device of 230=V AC must correspond to the ex-
istent mains voltage.
Never lift, carry or suspend the device by using the power cable.
Make sure that the electrical plug connection is protected from flood and moisture.
Before working on the pond pump disconnect the it from the current.
Avoid exposing the appliance to a direct water jet or rain.
The user is responsible for the compliance with location specific safety and installing regula-
tions. Ask an electrician if you have any question.
Consequential damage arising from flooded rooms caused by dysfunctions of the appliance
must be avoided by means of the appropriate measures. (installing an alarm system, reserve
pump).
In case of malfunction, the repair work can be carried out only by a qualified electricial.
The appliance must not run dry or with a completely closed intake port. The manufacturer’s
guarantee is no longer valid if the damage is caused by dry running.
The appliance must not be used for swimming pools.
The device cannot be employed for drinking water circuits.
© by WilTec Wildanger Technik GmbH Item 50199–50220 Page 3
http://www.WilTec.de
http://www.aoyue.eu 11 2020-1
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
