WARNING:
Read carefully all the safety guidelines and instructions. Non-compliance with the safety rules and reg-
ulations can lead to an electric shock, fire and/or serious injury.
Keep the instructions and the safety guidelines in a safe place in case you need them in the future.
Stability
The max. temperature of the transported liquid should not exceed +35°C in permanent operation.
The transport of aggressive fluids (acids, bases, etc.) as well as of abrasive substances (for example
sand) must be avoided.
Electrical connection
The electrical connection takes place via an electric safety socket of 230=V ~ 50=Hz. Fuse pro-
tection at least 10=A.
The engine is protected against overloading or blocking by means of a built-in motor protec -
tion. In case of overheating, the pump is turned off automatically due to the overheat protec-
tion, and after having cooled down, the pump is automatically started.
Power connection
The pond pump is equipped with a safety plug. The device is designed for connection to an isolated
ground receptacle with 230=V~50=Hz. Make sure that the socket outlet is sufficiently fused (at least
6=A) and safe. Insert the plug in the socket outlet and the pond pump is ready for use.
Note:
Installation
Please put the pump under water and make sure that no water may get into the socket.
Image 1
The pump is to be installed as follows: in a fixed position with fixed or flexible hose.
Utilisation as submersed pump (see image 1)
Immerse the pump into the pond water so that it is filled with water.
To prevent the filter from prematurely blocking, position the pump above the pond mud.
The pump is started by plugging in the mains plug.
© by WilTec Wildanger Technik GmbH Item 50199–50220 Page 4
http://www.WilTec.de
http://www.aoyue.eu 11 2020-1
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
