Wintering
1. Take the pump out of the water and disconnect it from the power supply.
2. Clean the pump as described in the instructions.
3. Check the pump for damage such as cracks in the housing.
4. Please store the pump under frost-free condition and, if possible, in a container with water.
Maintenance and cleaning
Image 1:
Adjust the flow rate.
Image 2:
Turn the filter case in the direction of arrow, then take it out.
Image 3:
Press the blue button in order to open the filter housing.
Image 4:
Keep hold on the blue switch and rotate the flap on the motor housing in the direction of arrow.
Image 5:
Pull the impeller and the pump shaft out of the housing to clean them.
Image 6:
Make sure that the O-ring is properly mounted again before you reassemble the pump.
© by WilTec Wildanger Technik GmbH Item 50199–50220 Page 6
http://www.WilTec.de
http://www.aoyue.eu 11 2020-1
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
