Page 5<&(%$*4.8"4,7%J'*#$"&8#K%/7*,#*%4,77%HLMMMLMIILNOPO1Item 63395
?@<6AQRS6;@ACRED@CEA6E@ET6 ?6AFS
?*$'/%L%W*2&(*%F#*-
% ;*,9%$.*%6EAC;6%CDSR;A@EA%?@<6AQ%CE<R;D@ACRE%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*Z$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
E&$*- For additional information regarding the parts listed in the following
pages, refer to Parts List and Diagram on page 10.
E&$*- More than one person is needed for proper assembly.
1. Insert Connecting Nuts (8) into holes at ends
of a Cross Brace (F). Make sure that the
slots on the Nuts align horizontally. This will
allow the Bolts to be threaded into the Cross
Brace in the next step. Refer to Figure 1.
T&88*4$"83%
E'$#%]M^
G*3%
]@LGK%@L;^
T(&##%W(,4*%]<^
<"3'(*%H
2. Set the Cross Brace against a Leg (A-L)
DQGXVHWKH+H[.H\DQG[PP
Connecting Bolts (7) to fasten the Cross
Brace and Leg together. Refer to Figure 2.
T(&##%%
W(,4*%]<^
G*3%
]@LGK%@L;^
B*Z%%
_*>%]P^
<"3'(*%`
ERA6- Make sure the groove in the
Cross Brace is facing IN.
3. Repeat Step 2 for the second Leg (A-R).
4. Once both Legs have been fastened to the Cross
Brace, slide the Bottom Shelf (G) between the
Legs so that the far edge fits onto the groove
on the Cross Brace. Refer to Figure 4.
T(&##%%
W(,4*%]<^
G*3%
]@LGK%@L;^
W&$$&5%
?.*72%]V^
<"3'(*%a
5. Set the second Cross Brace against the other
edge of the Bottom Shelf. Refer to Figure 5.
W&$$&5%
?.*72%]V^
T(&##%%
W(,4*%]<^
<"3'(*%N
6. Once the Cross Brace is in place and the
mounting holes on the Legs are aligned with
the Connecting Nuts in the Cross Brace, use
the Hex Key and Connecting Bolts to fasten
the second Cross Brace to both Legs.
To Next Page
Loading...
