OPERATION
Clipper
WINDSOR
01)
Install jets and brush.
05)
Adjust handle for push or pull
cleaning and operator height.
04)
For spotting:
Hook up vacuum
line, solution line, and tool if
necessary.
02)
Fill solution tank with extraction
rinse or fresh water and replace
the lid properly. The notch on the
lid should match up with the notch
in the tank.
06)
Turn on brush motor.
03)
Make sure that all three prongs
are on the main body of the cord.
iF one oF the prongs is missing, notiFy
your supervisor. Plug in to outlet and
machine cord and twist to lock.
07)
Starting at the highest set-
ting, adjust brush height set-
ting by setting until you hear
the brush hit the carpet.
To Next Page
Need help?
General
