To Next PageTo Next PageWhat to do if my Windsor Floor Machine has no power?
If your Windsor Floor Machine isn't turning on, first, ensure the cord is properly plugged in. If it is, check the building's circuit breaker and reset it if necessary. If the problem persists, it could be a faulty switch or power cord, requiring professional service.
Why does my Windsor Floor Machine have poor suction?
If your Windsor Floor Machine's vacuum motor is running but the suction is weak, there might be debris lodged in the vac shoe; remove any obstructions. Check the dome gasket and replace it if it's defective or missing. Inspect the vacuum hose for cracks or loose cuffs, repairing or replacing as needed. Ensure the vac shoe angle is correct and that the recovery tank isn't full, potentially causing the float ball to stick. Also, the vac shut-off may be engaged, so drain the recovery tank.
How to fix a Windsor Floor Machine brush that won't spin?
If the brush on your Windsor Floor Machine isn't spinning, ensure the brush switch is turned on. Check the circuit breaker and reset it if tripped. Make sure the propel lever is squeezed to activate the brush. Inspect the brush belt and replace it if broken.
General| Brand | Windsor |
|---|---|
| Model | Commodore 20 CMD20 |
| Category | Floor Machine |
| Language | English |
