Windsor Commodore 20 End User Guide

OPERATION
Commodore 20
WINDSOR
01)
Install jets and brush.
05)
Pull lever to release brush
deck and turn vacuum on and
turn brush on.
04)
Make sure that all three prongs are
on the main body of the cord. If one
of the prongs Is mIssIng, notIfy your su-
pervIsor ImmedIately. Plug in to outlet
and machine and twist to lock.
02)
Fill solution tank with extrac-
tion rinse or fresh water.
06)
Choose speed. Use slower
speeds for deeper cleaning
and faster speeds for
lighter cleaning.
03)
Make sure that the handle is in the upright po-
sition and adjust the brush height by pushing
down on the vacuum shoe and turning the lever
and castle nut. Start at level 2 and adjust ac-
cordingly as brush wears. If the breaker trips,
back off on the pressure on the brush.
07)
Grab handle to engage the
brush and solution.

Windsor Commodore 20 Specifications

General

Electrical	230V, 8 A, 50 HZ
Power Cable	75’ (23 m) (12 gauge)
Electric Propelling Motor	(1) –1/4 hp DC (186 watts) with variable speed forward.
Electric Vacuum Motor	(1) – 3 stage, 1 hp 99 cfm (2.80 m³/min.)
Drive System	Transaxle unti variable speed Operating Speed: 0-100ft/min (30m/min)
Waterlift	117” (297 cm)
Brush Speed	1000 RPM
Solution Capacity	20 Gallons (75 ltr)
Recovery Capacity	20 Gallons (75 ltr)
Brush	(1) 18” (45.8 cm)
Solution Pump	100 psi (6.9 BAR), diaphragm style, demand pump
Solution Spray	2 quick change jets
Vacuum Shoe	22” (56 cm) wide, cast urethane floating and pivoting.
Wheels - Front (2) - Rear (2)	4” dia. (10 cm) caster by 2.5” 10” dia (25 cm) wheels by 2”

Weight and Dimensions

Dimensions - Weight	215 lbs. (98 kg)
Dimensions - Length	51” (130 cm)
Dimensions - Height	44” (111 cm)
Dimensions - Width	22” (56 cm)