Equipment Basics Course
!
!
A!Member!of!KÄRCHER!North!Amer ica!
beginners. Brushes and/or pads are attached directly to the bottom of the
machine. Typically a red pad is used for daily scrubbing and a black pad is used
for stripping. Windsor products include:
Windsor Low Speed Machines
Storm 13“
Storm 17” Deluxe
Storm 20” Deluxe
1.009-022.0
1.009-028.0
1.009-032.0
• All metal construction
• Dual Capacitors
• Conveniently placed handle release
Dual Speed
These floor machines are similar to the above units, but their higher
speeds — up to 300 rpm — make them better suited for spray buffing
and stripping. Since these units are dual-speed, the user can switch
between the higher (300 rpm) and lower rpm for scrubbing or stripping
and faster rpm for polishing. Windsor products include:
Windsor Dual Speed Machines
• All metal construction
• DC Rectified motor provides more stable amp draw
• Conveniently placed handle release
Ultra High Speed Burnishers
These machines range in size from 17” to 20” and rotate at 1000 to
more than 2,500 rpm. Ultra high speed burnishers are used to
increase shine and repair scratched floors on today’s floor finishes.
High speed machines employ the use of specially coated pads that
when spinning, “cut” the finish to create a smooth (shiny) surface.
This dry process is called “burnishing”. Because of this higher speed
and friction, they are able to produce the “wet look” many facility
managers prefer. High speed burnishers are available in cord electric, battery or
propane models. Some burnishers have built in dust control systems that are
able to contain the powder or dusting created by the high rpm’s of the machine.
Windsor products include;
Windsor Ultra High Speed Burnishers
• Top mounted handle lock
• Top mounted handle lock
• Passive dust control system
• Passive dust control system
• Passive dust control system
• Traction drive
To Next Page
Loading...
