Windsor Versamatic User Manual

OPERATION
Versamatic and Versamatic Plus
WINDSOR
01)
Inspect brush for wear using a
credit card and replace if neces-
sary. (Screwdriver necessary
to remove the brushes on some
models)
05)
Unplug the cord from the
wall.
04)
Starting at the highest
setting, adjust brush height
setting by setting until the
orange light turns off.
02)
Make sure all three prongs are
on the body of the cord and plug
into an outlet. if one of the Prongs
is missing, notify your suPerVisor.
06)
Hold the strain relief in an up-
right position so that the strain
relief will not be damaged when
the cord is wrapped.
03)
Turn the machine on.
07)
Wrap the cord for storage start-
ing from the base. Wrapping the
cord properly will help prevent
cord failure.

Windsor Versamatic Specifications

General

Model	Versamatic
Type	Upright Vacuum Cleaner
Category	Commercial Vacuum Cleaner
Power	1000 W
Voltage	120 V
Filtration	HEPA
Tank Capacity	Not applicable
Weight	18 lbs
Warranty	1 year
Cord Length	40 ft
Hose Length	Not applicable
Noise Level	69 dBA
Filter Type	HEPA

Summary

Operation Instructions

Inspect and Replace Brush

Check brush for wear using a credit card and replace if necessary. A screwdriver might be needed for some models.

Verify Power Cord and Plug

Ensure all three prongs are on the cord and plug into an outlet. Notify supervisor if a prong is missing.

Powering On the Machine

Turn the machine on to begin operation.

Adjusting Brush Height Setting

Starting at the highest setting, adjust brush height until the orange light turns off.

Disconnecting Power Cord

Unplug the power cord from the wall outlet when finished.

Securing Cord Strain Relief

Hold the strain relief in an upright position to prevent damage when wrapping the cord.

Proper Cord Storage

Wrap the cord for storage starting from the base to prevent cord failure.

Maintenance Procedures

Accessing Covers

Release lever to remove the front cover (Versamatic Plus) or back cover (Versamatic).

Replacing Dust Bag

Replace the dust bag when it is full. Different bags exist for Versamatic Plus and Versamatic.

Replacing Filters

Replace filters quarterly. Separate filters are available for Versamatic Plus and Versamatic models.

Clearing Hose Clogs

To remove a clog from the hose, press buttons to detach it and clean with a broom handle.