Winegard is a registered trademark of Winegard Company, and Pathway is a trademark of Winegard Company.
DISH is a registered trademark of DISH Network L.L.C.
Q. How should the Pathway X2 antenna be positioned?
A. The Pathway antenna should be positioned with cable connections pointing approximately North.
Q. Should I choose eastern or western arc during receiver setup?
A. Generally, western arc will be available in almost all areas of the continental US. When in the eastern half of the US,
the eastern arc may provide better look angles and possibly local channels if you are within your home market.
Q. How do I access the receiver setup menu after initial receiver setup?
A. Press “Menu” on your remote. Select option 6, “System Setup.” Then, select option 1, “Installation.” Select option 1
again, “Point Dish.” Finally, select “Check Switch.” Adjust settings as desired.
Q. Do I need to go through all receiver setup steps every time I use the antenna?
A. Every time the antenna is moved to a new location, you will need to complete receiver setup. Simply choose the
number of receivers (one or two), eastern or western arc satellites (no selections need to be made if “Two” was
selected for receivers), and the state that you are currently in. Then, select “Scan” to begin scanning for satellites.
Q. What do I need to set up the Pathway X2 antenna?
A. You will need a TV and an activated receiver with programming package. The antenna must be used with a DISH
Solo HD receiver; examples include DISH 211k, 211, 411, and 211z receivers.
Accessories
Q. Is the Pathway X2 antenna compatible with the Carryout ladder mount?
A. No—the antenna is not compatible with the Carryout ladder mount. Installing the antenna on the Carryout ladder
mount on a moving vehicle may lead to serious injury and/or equipment and property damage.
Q. Is the Pathway X2 antenna compatible with the TR-1518 tripod mount?
A. Yes, the Pathway X2 antenna is compatible with the TR-1518 tripod mount. However, the Pathway X2 antenna
accommodates two locations for the rubber support feet. In order for the Pathway X2 antenna to be placed on the
TR-1518, the feet must be in the inside position.
Troubleshooting
Q. What should I do if the Pathway X2 antenna stops working or if I can’t set up the antenna properly?
A. Contact Winegard Technical Services by emailing help@winegard.com or by calling 1-800-788-4417.
To Previous Page
Loading...
Need help?
General