9
English
50BT, 70BT
OPERATION
1.
Bucket
Using this method requires the bucket to be emptied manually when full.
①
Slide the bucket out of the unit by
grasping the side handles.
②
Empty the bucket in a basin with a drain;
ideally a sink.
③
After the bucket is emptied, the bucket will need to be replaced by sliding
the bucket back into the unit.
2.
Gravity Drain Hose
This method will allow a hose to be connected to the rear of the unit, allowing for
continuous flow and disposal of any water collected from the air. (hose not provided)
①
Remove the Gravity Drain cap.
There are two options to operate the unit, bucket or Gravity Drain Hose.
To Next Page
Loading...
Need help?
General
