7-3
SECTION 7 –
PLUMBING
slow leak in a faucet could drain the water tank,
fill the holding tank, and discharge the house
batteries.
Initial Waterline Priming
1. Ensure that all water drain valves are closed,
including water heater valve.
2. Turn Water Pump switch to “OFF” position.
3. Fill water tank.
4. Open all faucets, hot and cold.
5. Turn ON the Water Pump switch.
6. Close each faucet as it begins to deliver a
steady stream of water (close cold water first).
Leave hot water faucets on until they also
deliver a steady stream of water. This will
ensure that the water heater is filled with
water.
7. Check to ensure the Water Pump stops soon
after all faucets have been closed.
8. The Water Pump is now ready for automatic
operation. The pump will start when a faucet
is opened and stop when the faucet is closed.
Further Information
Refer to the Water Pump manufacturer’s
operation, care, and maintenance information
provided in your InfoCase.
DISINFECTING YOUR FRESH
WATER SYSTEM
(As required by NFPA
®
1192 Standard on
Recreational Vehicles)
To ensure complete disinfection of the potable
water system, it is recommended that the
following procedure be followed on a new
system, one that has not been used for a period of
time, or one that could have become
contaminated.
Water Pump
•Model 23A - located inside a passenger side
compartment
-Typical View
Water Pump
• Model 23F - Located beneath bed
(remove panel to access).
-Typical View
Water Pump
• Model 23T - located beneath
galley (remove panel to access)
-Typical View
To Next Page
Loading...
Need help?
General
