EasyManua.ls Logo

Winnebago Trend - Page 26

Winnebago Trend
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 3 –
DRIVING YOUR MOTORHOME
3-4
4. Review the instructions for installation and
use of the restraint. Be sure that you
understand them fully and can install the
restraint properly and safely in your vehicle.
Tether Anchor Loop
-If Equipped
If your coach has a dinette, it may be equipped
with a child seat tether anchor loop located
beneath the forward facing dinette seat cushion.
1. Lower the dinette table.
NOTE: The dinette table must be in the lowered
position when a child seat is in use.
2. Set child seat upright on dinette seat.
3. Route the tether over the top of the dinette seat
back and hook it to the anchor loop (located
beneath the forward facing dinette seat
cushion). Pull tether strap to tighten.
4. Route the shoulder belt through the child seat.
Fasten the shoulder belt and pull snug. The
locking tab automatically holds the belt in
place.
Tether
Anchor
Loops
-Typical View
NOTE: Your coach may have one or two
tether anchor loops depending on
model.
3. Tether
4.
Shoulder
Belt
Tether hooked to
anchor loop

Table of Contents