Winters DPG - User Manual

DPG
Digital Pressure Gauge Instructions
Tel: 1-800-WINTERS / www.winters.com WINTERS INSTRUMENTS
Menu Button
• Press
- Changes pressure units
(psi, mH
2
O, mmHg, mbar, kPa ranges ≤ 100 psi,
psi, bar, kgf/cm
2
, MPa, atm ranges ≥ 160 psi)
• Hold for 4 - 5 Seconds and Release
- Reset to zero
(This process will take a few seconds)
Power Button
• Press
- Turns gauge ON for about 1 minute and displays
battery reading. Backlight* will stay ON for about 10 seconds
- Turns gauge OFF (hold for 2 seconds)
• Press While ON
- Turns backlight* back ON for about 10 seconds
* backlight automatically comes ON when pressure
changes ±10% of scale (when gauge is ON)
LCD Display
Battery Reading
Pressure Reading
Pressure Scale (units)
1.
2.
3. 4.
5.
To Change Batteries
1. Remove Rubber Boot
2. Remove Top Phillips Screw to Open Cover
3. Exchange Batteries (Two AAA Batteries)
4. Close Cover and Re-install Screw
5. Re-install Rubber Boot

Winters DPG Specifications

General

Type	Digital Pressure Gauge
Display	LCD
Units	psi, bar, kPa, MPa
Operating Temperature	-10°C to 50°C
Process Connection	1/4" NPT
Power	Battery
Output	4-20 mA
Material	Stainless Steel
Measurement Range	Vacuum to 15, 000 psi

Summary

Gauge Operation Overview

Power Button Functionality

Controls gauge power on/off and backlight behavior.

Menu Button Functionality

Changes pressure units and allows resetting the gauge to zero.

Battery Replacement Procedure

Step-by-step instructions for replacing the gauge batteries.

Setup Options

Auto;Manual Shut Off Modes

Selects automatic or manual display shut off.

Display Modes

Configures the display to show actual or peak process pressure.