34
WINYCAM BRAVO
사
용
하
기
How to use
After firmware update completed, the touch calibration will run to ensure for accurate touch sensitivity.
Press the “DONE” button after thatching 4 yellow points to finish the Touch Calibration properly. If you have
pressed “RESET” button by mistake, BRAVO will re-boot and complete the Touch Calibration procedure.
Note
Firmware Upgrade
1. Auto Firmware Upgrade
2. Manual Firmware Upgrade
1) Remove the SD card from BRAVO after turning off the power completely.
2) Backup all files that are stored in the files to your PC.
3) Format a SD card on PC. (Please refer “how to format” in the quick guide)
4) Download the latest firmware from our website (http://www.winycam-eng.com) and copy to a SD card.
5) Insert the SD card to BRAVO. After power ON then firmware will be updated automatically.
6) During firmware updating, a voice guide will be announced and updating massage will be displayed ion LCD.
7) When the firmware update is completed, BRAVO will be initialized and a voice guide will be announced
1) Insert a SD card which new firmware is stored to BRAVO.
2) “Menu > Other Setting > FW Update”
3) Same progress as above step (6) in auto firmware update.
To Next Page
Loading...