EasyManua.ls Logo

WinZo AN5024 - Page 2

Default Icon
3 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WINZO
WINZO WINZO
WINZO WINZO
WINZO
TROUBLESHOOTING
Poor Flush / little or no
flush volume
water level is too low Adjust the water level
Install refill tube correctly (see
diagram on the right)
Issue Cause Solution
RIGHTWRONG
Water Level
Leaking/water in tank
fails to shut off.
Refill tube wasn’t installed
properly.
Push button rod too long Cut-off the extra length then re-adjust.
Inlet valve float crashed against ceramic wall
Adjust inlet valve position
Debris in water is affecting the flush valve
Remove flush valve ,clean and reassemble
The flush valve and base,rubber gasket does
not fit properly.
Remove flush valve ,adjust gasket, reassemble.
Shut-off valve is not fully open Turn on the valve fully
Push button rods too short
Re-adjust length of the rod (outward rotation
Filter screen is clogged due to dirty water
Clean the filter screen
CARE AND CLEANING
For general cleaning, wash with warm water, a soft sponges or soft-cloths. Always rinse thoroughly any cleaning solutions
immediately after cleaning. Do not any chemical remain on the surface for extended periods of time.
Do not pour any mounts of chlorine or any other chemicals into the tank. Use of chemical products will result in damage to the fill valve and
flush valve components and may cause flood and property damage.
IMPORTANT!
DO NOT USE: Abrasive cleaners such as: acid, ammonia, bleach, and simmilar solutions. Use of such solutions may cause
corrosion, finish peeling, and/or dull the surface.
DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the surface.
WARRANTY
Vitreous China is guaranteed for five years from date of purchase subject to the conditions below.
Internal valving and plastic components are guaranteed for one year from date of purchase subject to the conditions below.
CONDITIONS
· This product has been installed by a licensed plumber in accordance with the installation instructions.
· This product has been installed for home use only.
· Failure is due to a fault in the manufacturer of the product.
· No additives have been introduced into the toilet tank.
· Only soft sponges or soft- cloths has been used to clean the product.
· Proof of purchase is required for warranty claims
2/3

Related product manuals