Wired Home SS4 - User Manual

Impedance Matching Speaker
Selector
User Manual
2
Introduction
The Wired Home SS4, SS6 and SS8 are low-profile
speaker selectors that allow you to distribute a
stereo speaker-level (amplified) signal to multiple
listening zones. These speaker selectors feature a
manually activated impedance protection circuit.
The protection switch can be turned ON to prevent
the impedance to your amplifier from dropping
below 5 Ohms, regardless of the number and
impedance ratings of your speakers. The protection
switch can be turned OFF when used as part of a
system incorporating impedance matching volume
controls, allowing you to get the most out of your
amplifier.
The terminals on the rear of the speaker selector
will accommodate up to 14 gauge cable; sufficient
for cable runs exceeding 100 feet. For shorter
distances, 16 ~ 18 gauge cable will suffice. For in-
wall installations, we recommend using CL-2 or
CL-3 rated cable for compliance with local building
codes. If unsure, contact you local building
inspector. When connecting a speaker and
amplifier, it is important to maintain polarity;
positive (+/red) to positive and negative (-/black) to
negative. Be careful to maintain correct polarity
between the amplifier, the speaker selector, the
volume controls and the speakers.

Summary

Introduction to Wired Home Speaker Selectors

Product Description and Impedance Protection

Explains the SS4, SS6, SS8 selectors and their impedance protection circuit for amplifier safety.

Wiring and Installation Recommendations

Covers cable gauge, in-wall ratings (CL-2/CL-3), and crucial polarity maintenance.

Installation and Wiring Procedure

Connecting Speaker Cables and Setting Protection

Step-by-step guide for routing cables, preparing conductors, making connections, and setting protection.

Product Specifications Table

Warranty Information

Warranty Terms and Exclusions

Details the one-year limited warranty, repair/replacement policy, and warranty exclusions.

Wired Home SS4 Specifications

General

Model	SS4
Category	Recording Equipment
Connectivity	Wired
Video Output	HDMI, VGA
Recording Resolution	1080p
Channels	4
Motion Detection	Yes
Remote Viewing	Yes
Compatibility	iOS, Android