Need help?Do you have a question about the Wireless Devices P-900 and is the answer not in the manual?
General| Brand | Wireless Devices |
|---|---|
| Model | P-900 |
| Category | Transmitter |
| Language | English |
Download the app using a QR code reader via smartphone.
Install the app, open it, and initiate adding a new station.
Select the IoT Station and set a password for it.
Enter the Wi-Fi password to connect the IoTStation to the internet.
Download the iOS app using a QR code scanner on your smartphone.
Input the IoT station's password and the Wi-Fi password for the AP.
Confirm the IP address allocated to the IoT Station by clicking OK.
The IoT Station is now online and ready for use after successful configuration.
Press the Match/Reset button to initiate pairing mode; the Sub-1GHz LED will blink.
Press the transmitter's TX button; the LED blinking stops upon successful addition.
Press and hold the Match/Reset button for over 15 seconds to perform a factory reset.
To Next Page