Need help?Do you have a question about the Wisecomm cw3510tx and is the answer not in the manual?
General| Model | CW3510TX |
|---|---|
| Connectivity | Wi-Fi |
| Night Vision | Yes |
| Motion Detection | Yes |
| Weather Resistance | IP65 |
| Type | Wireless Camera |
| Resolution | 1080P |
Connect the supplied adaptor to the DC IN jack on the rear of the camera and plug it into AC power outlet.
Connect the supplied AC adaptor to the DC IN jack of the receiver and plug it into AC outlet.
Select the same channel with the SEL button on the receiver as the channel of the camera.
Press SEL button on the receiver after CH 4 indicator is lit to enter sequencing mode.
Connect the supplied A/V cable to the TV's A/V jacks and the receiver's A/V jack for audio/video output.
Connect A/V cable to VCR's A/V jacks and VCR's output to TV/monitor for video and audio.
Details on receiving frequency, demodulation, antenna, sensitivity, video/audio output, power, and consumption.
Details on output level, operating frequency, modulation, video/audio input, and image sensor.
Details on pixels, resolution, scanning system, illumination, S/N ratio, shutter speed, lens, and operating temperature.
Instructions for returning the system for repair, including warranty card and shipping details.
To Next Page