7
STOVE PIPE INSTALL/ HELPFUL HINTS
Install vent at clearances specified by the vent manufacturer.
WARNING: Do not compromise instructions for installation or make changes to
manufacturers specifications during the installation of this product.
Attach and secure the exhaust venting system to the product and to each adjoining section.
All joints for connector pipe are required to be fastened with 3 screws.
A NON-FLAMMABLE PAD MUST BE INSTALLED THAT MEETS UL 1618
REQUIREMENTS OF 3/8” NON-COMBUSTIBLE MATERIAL.
Minimum hearth requirements USA – 25”D X 44” W
Minimum hearth requirements Canada – 25”D X 46”W
WiseWay Pellet Stoves Inc. grants no Warranty, implied or stated, for the installation or maintenance of your stove, and
assumes no responsibility of any consequential damage(s).
To Next Page
Loading...
