p.34
Enter the unlock code for your scooter below:
Now that the code lock is activated, each time you start it, your scooter will ask you
for your code (two digits).
To unlock the scooter, turn it on by pressing 3 seconds, then enter your code, then
press twice .
Disable passcode lock.
To deactivate the code, unlock your scooter. Then press the start button 7 times .
Then type your code once. You will be asked for a second entry, instead of entering a
new code (you have the choice to change the code by entering a new code or to
deactivate the password) squeeze the brake handle until you hear a “Beep” to
deactivate the code.
ATTENTION !If you deactivate your code, the default code will be
your old code.
The scooter turns off by itself and locks (if the code is activated) after
5minutes of inactivity.
To Next Page
