4) FAN SPEED
• Set the fan knob to the "HIGH" or "LOW" position.
• The cooler may be used as a fan only, this is
done by turning the "COOL" knob to the "OFF"
position. (see Fig 8)
5) OSCILLATION
• Set the oscillation knob to the "ON" position.
(see Fig 10)
How to get the best cooling performance:
1) Place the cooler with its back near an open
window or door so it can draw in 100% fresh
outdoor air. Open another window or door on the
opposite side of the room for "flow through"
ventilation. This cooler will not cool properly in a
closed room.
2) We recommend that when the cooler is first used
it should be run for 10 minutes in the "COOL", "HIGH"
setting.
HIGH
OFF LOW
©
AIR
(Fig.9)
OFF
OH
©
OSCILLATION
(Fig.10J
CAUTIONS
Safety instructions:
As this cooler contains water, ensure it is moved
carefully and is not tilted or bumped as water may spill.
Always unplug the cooler from the electrical receptacle
before moving or servicing the cooler.
(Fig 11)
(Fig.11|
Do not place anything on top of the ceole_
(Fig 12)
(Fig. 12)
(Fig. 13)
Cleaning: (Unplug the cooler from the electrical
receptacle before cleaning)
The exterior surfaces can be wiped with a damp
cloth and a little household detergent. Do not use
abrasive cleaners or solvents,
To Next Page
