4. Before Every
Ride
Are the quick release levers and thru axles on the seat post and front wheel correctly fixed?
Are the tyres in good condition and do both tyres have sufficient pressure? Check the tread for excessive wear and the
side walls for any sign of cracking. Low pressure tyres raise the risk of punctures and also put excessive strain on the
motor of your eBike. Maximum and minimum pressures can be found on the sides of the tyres.
Test the brake operation - Pull the brake levers towards the handlebar. The levers should come to a firm stop after
travelling only a short distance. THE LEVER MUST NOT TOUCH THE HANDLEBAR.
Check the electronic functions? Are there any error messages or warnings on the display?
Check the battery for any visible signs of damage
Check the lights are working
Take into consideration riding conditions. Be aware that in wet and icy conditions brake and tyre performance is
reduced.
Be sure to check the following points before every ride, not doing so could result in accidents or severe injuries.
If you have any doubts do not ride the bike and contact your Wisper Dealer or Wisper Support
To Next Page
Loading...
