Wittenborg IN 7600 - Reference Card Error Types; Branch Pipe Error; Cup Elevator Error; Cup Not Delivered or Use Own Cup

Reference Card Error Types
3
Display Possible cause Possible action
message
Branch
pipe error
Cup
elevator
error
Cup not
delivered
or
Use own
cup
Cup
storage
error
Cup
transport
error
Door open
Waste
bucket full
Temperature
low
Water tank
overboil
Cup blocking the movement of the
branch pipe.
Grease or dirt blocking the movement
of the branch pipe.
Cup on elevator when machine is
switched on.
No more cups.
Dirt or grease blocking cup slide.
No cups in cup magazine
Cup pile blocked.
Cup slide blocked.
Door not closed properly.
Waste bucket full.
Waste bucket sensor soiled.
The machine has been turned on
recently.
Overboil thermostat has triggered.
If it was impossible to remedy the fault, or other type of display message is shown,
please contact the service.
Switch machine OFF and ON.
Remove cup.
Clean cup catcher and cup slide areas.
Remove cup.
Load cups in cup magazine.
Clean cup slide.
Use own cup / load cups in cup
magazine.
Remove blocking cup.
Remove blocking cup.
Close door properly.
Empty waste bucket and wipe dry
sensor.
Clean and wipe dry sensor.
Wait until the water is heated sufficiently
(maximum 13 minutes).
Press reset button.