Reference Card Error Types (continued)
Error Possible cause Possible action
types
No display
or machine
not
operating
No
ingredient
Leak in
mixing
system
or
Mixing
system
overflows
Bucket
filled with
water
Machine
does not
shut down
when
bucket is
full
Poor
flavour of
drink
Inadequate
quantity of
drink
Coins
sticking
Machine
dispenses
free drinks
Sensor in waste bucket
is wet.
No power.
Canister empty.
Canister not correctly connected.
Ingredient sticking to auger drive
mechanism.
Mixing funnels/hoses not correctly
connected.
Whipper seal leaking or not installed.
Blockage in mixing funnels or
dispensing tubes.
Water dripping from hot water hoses.
Liquid has been poured into machine.
Foreign body clogging sensor for
bucket.
Sensor not in bucket.
Wrong ingredients.
Dispensing system dirty.
Ingredient residues clogging
dispensing outlet system.
Kink in outlet hose.
Coin mechanism sticking
Coin track dirty, greasy or blocked.
Cup lock function activated.
Price set to 0.00.
Price set to free vend.
Empty bucket and dry sensor.
Check fuses/power cord.
Refill canister.
Reinsert canister correctly.
Remove canister, clean auger drive
mechanism and reinsert.
Reinstall and reconnect components.
Replace whipper seal.
Replace/clean blocked part/s.
Water tank and valves must be
decalcified / replaced.
Instruct customers not to pour liquids
into machine.
Clean sensor.
Reposition sensor correctly in bucket.
Use corrrect ingredients.
Replace/clean components and rinse
thoroughly.
Replace/clean clogged component/s.
Install hose of correct length.
Press coin return button.
Clean coin track. cf. manual of supplier.
Wait for 10 seconds.
Set correct price.
Switch off free vend.
If it was impossible to remedy the fault, or other type of display message is shown,
please contact the service.
4
To Next Page
Loading...
