Wizard WA20H42STA - User Manual

Questions and Answers

B
bethany26Sep 13, 2025
Why Wizard WA20H42STA battery will not charge?
- A
  adamwalkerSep 13, 2025
  If your Wizard Lawn Mower battery isn't charging, it could be due to bad battery cells, poor cable connections, a faulty regulator (if equipped), or a faulty alternator. Replace the battery, check/clean all connections, and replace the regulator or alternator if necessary.
W
Wendy AllenSep 15, 2025
Why Wizard Lawn Mower has loss of drive?
- N
  nwhiteSep 15, 2025
  A loss of drive in your Wizard Lawn Mower may be due to the freewheel control being in the “disengaged” position, a worn, damaged, or broken motion drive belt, or air trapped in the transmission. Place the freewheel control in the “engaged” position, replace the motion drive belt, and purge the transmission.
A
Andre HenrySep 18, 2025
Why Wizard Lawn Mower engine “backfires” when turning engine “OFF”?
- E
  enunezSep 18, 2025
  If your Wizard Lawn Mower engine backfires when turning it off, it may be because the engine throttle control was not set at the “SLOW” position for 30 seconds before stopping the engine. Move the throttle control to the “SLOW” position and allow it to idle for 30 seconds before stopping the engine.
A
Ariana PatelNov 23, 2025
What to do if Wizard WA20H42STA Lawn Mower has loss of power (continued)?
- J
  Joseph RangelNov 23, 2025
  Continued loss of power in your Wizard Lawn Mower can stem from several issues. Check for buildup of grass, leaves, and trash under the mower and clean it. A dirty air filter, low or dirty oil, a faulty spark plug, or a dirty fuel filter could also be to blame. Stale or water-contaminated fuel, a loose spark plug wire, dirty engine air screen/fins, or a dirty/clogged muffler might also cause this. Loose or damaged wiring can also contribute to power loss. Clean under the mower, clean or replace the air filter and muffler, check/change the oil, clean/regap or change the spark plug, replace the fuel filter, drain and refill the fuel tank, connect/tighten the spark plug wire, and check all wiring. For carburetor or engine valve adjustments, consult the service manual or an authorized service ...