To Next PageTo Next Page
Need help?Do you have a question about the Wize AU65 and is the answer not in the manual?
General| Brand | Wize |
|---|---|
| Model | AU65 |
| Category | Racks & Stands |
| Language | English |
Severe personal injury and property damage can result from improper installation. Read warnings before beginning.
Do not use for unapproved purposes. Wize is not liable for damage from incorrect mounting, assembly, or use.
Hardware for solid wood, concrete, block. Consult installer for other materials like hollow bricks.
Do not exceed the maximum weight capacity for this product.
Specifies maximum screen weight capacity as 80lb / 36kg.
Lists required tools: drill bits for wood/masonry, hammer.
Use a stud finder to locate and mark the centers of two studs.
Use a level to draw a vertical line at the stud center.
Use the wall plate to mark hole locations on the center line.
Drill 65mm deep holes using a 4mm wood bit on the marks.
Use a level to make a vertical line on the wall.
Use the wall mount to mark hole locations on the line.
Drill 65mm deep holes using a 10mm drill bit on the marks.
Insert anchors into holes and tap with a hammer if necessary.
Fasten the wall plate to the wall using screw (A).
Place screw cover over the middle screw head for centering.
Bracket arms can be adjusted to fit various TV mounting patterns.
Use spacer if needed. Fasten adapters to TV using supplied hardware and screwdriver.
Use washers if screws bottom out to eliminate slack.
Hook TV onto adapter plate and secure with M5 screws and washers.
Level the TV to the desired position and tighten the securing screw.
Use part (Y) to attach the power cord to the arm.
Collapse mount arm until it clicks into a secure fixed position.
The product is covered by a 10-year warranty against defects in materials or manufacturing.
Wize disclaims liability for modifications, improper installations, and specification changes.
